Q100314: Wacom Pressure Sensitivity updates on Linux may cause issues with Mari and Nuke
Some Linux versions, such as RHEL/CentOS 7.4, are now shipping with a X11 Wacom driver (0.34.2) that has modified the existing pressure sensitivity range from 0 - 2048 to an extended 0 - 65535 range. This is causing issues with pressure sensitivity recognition in some products such as Nuke and Mari where sensitivity values above 2047 are ignored, causing unexpected behaviour for users.
NOTE: This issue has been addressed in Mari version 4.2v1 and later, however it is still present in current versions of Nuke and versions of Mari up to 4.1v2.
The latest Wacom driver has changed the sensitivity range from 0 - 2048 to 0 - 65535, which neither Mari or Nuke yet support. What this means is that, any pressure over 2048 (which on a range of 0 - 65535 would only cover 3% of all values) will not be registered by Mari, and so it will not draw.
Fig 1: An example of using the 0 - 2048 pressure sensitivity range in Mari.
Fig 2: An example of using the 0 - 65535 pressure sensitivity range in Mari.
In Nuke, this modification to the Pressure Sensitivity range can be examined when attempting to use the RotoPaint node. In the example below, only the lightest pressure is registered correctly when using the Clone Stamp brush; any pressure above the 2048 range creates unexpected results and incorrect, saturated colours when cloning and painting.
Fig 3: An example of using the 0 - 2048 pressure sensitivity range in Nuke
Fig 4: An example of using the 0 - 65535 pressure sensitivity range in Nuke
TP 280527 - Add support in Mari for extended pressure sensitivity levels introduced in new Wacom drivers
TP 280528 - Add support in Nuke for extended pressure sensitivity levels introduced in new Wacom drivers
Until we are able to offer support for this extended 0 - 66535 range, there are two possible solutions depending on the capability of your machine and whether or not the driver came pre-installed. You should try:
2) If you are unable to roll back your drivers, the latest release of the X11 Wacom Driver (0.35.0) contains support for a new xorg "Pressure2K" option that can be used to force the driver into reverting back to 2048 pressure levels. RHEL/CentOS 7.4, and above, also support this option.
Identifier "Wacom pressure compatibility"
Option "Pressure2K" "true"
We're sorry to hear thatPlease tell us why